Similar to Reverse Tuck except the top and bottom closing flaps are hinged on the same side of the box.
Pros
>
Product can be inserted from either top or bottom of the box.
>
Faster assembly time – box pops open only bottom and lid need forming.
>
Gives a good look to the face of the box as both flaps open on the same side and can be positioned at the back of the box.
Cons
>
Since flaps open on the same side of the box positioning this product for minimization of waste cannot be achieved through interlocking the design on die-cutting, thus increasing the cost of materials.
Uses
>
Smaller runs where multiple boxes on one sheet are generally not required or products where the appearance of the “face” of the box is important.